INVENSYS APPLIANCE CONTROLS S.R.O.

Our bed, where we spend most of our day, is very important for our health. Starting a new day ready, rested and happy is much easier with a quality mattress. Our mattress is produced with hercules spring technology that improves sleep quality. The top layer is woven from knitted fabric and the bottom layer is woven from sweatfree jacquard fabric. It can be used on both sides. One side knitted fabric and the other side jacquard fabric is used. Ventilation capsules are used on the side borders.

Dimensions Wire diameter: 0,2 – 8,0 mm Outside diameter: > 120 mm after consultation All wire profiles feasible Material All spring materials and quality steels with lower strengths Coating All commonly coated spring steels In-house phosphating In-house stove-enameling Additional coatings through external services Specialities Clamping rings made of round wire or flat material Clamping rings with a stamp Rings with defined bendings Minimum burr cut-geometry Additional processing available after consultation Customer specific packaging Rapid prototyping

Dimensions Wire diameter: 0,3 – 4,5 mm spring-hardened Wire diameter: 0,3 – 7,0 mm soft Profiles other than round wire after consultation Material All spring materials and quality steels with lower strengths Coating All commonly coated spring steels Additional coatings available after consultation Specialities Tight torsional tolerances Torsion springs with max. two coils (toggle springs) All kind of hook and leg configuration Rapid prototyping

Dimensions Wire diameter: 0,2 – 8,0 mm Spring length up to 1500 mm Special profiles feasible Outside diameter max. 120 mm Customer specific spring shape Material All spring materials Coating All commonly coated spring steels In-house phosphating In-house stove-enameling Additional coatings through external services Specialities Compression springs highly resistant against dynamic stress Compression springs highly resistant against static stress Minimal relaxation due to heat treatment Fully automated setting- and force-inspection Smallest force tolerances Customer specific packaging Assembling and mounting with other components Rapid prototyping